DOT issues NPRM on improved rear impact protection for trailers and semitrailers
Posted December 9, 2015
On December 7, the U.S. Department of Transportation's National Highway Traffic Safety Administration (NHTSA) issued a notice of proposed rulemaking (NPRM) that focuses on upgrading the Federal Motor Vehicle Safety Standards (FMVSSs) that address underride protection in light-vehicle crashes into the rear of trailers and semitrailers. The proposed rulemaking continues the agency’s initiative to upgrade the standards for truck and trailer rear impact crash protection. Earlier this year, NHTSA published an advance notice of proposed rulemaking on rear underride crash protection and visibility conspicuity of single unit trucks.
Most trailers and semitrailers are already required to have bars, known as rear impact guards, hanging down from the back of the trailer to prevent underride. To enhance underride protection, NHTSA proposes to require more robust rear impact guards on trailers and semitrailers. The agency says the more robust guards will help improve underride protection in higher speed crashes compared to current rear impact guards.
FMVSS No. 223 (Rear impact guards) and FMVSS No. 224 (Rear impact protection) together address rear underride protection in crashes into trailers and semitrailers. NHTSA estimates that many new trailers sold in the United States subject to FMVSS Nos. 223 and 224 demonstrate compliance with the more stringent performance requirements under consideration. NHTSA estimates, on average, that the annual incremental material and fuel cost would be $13 million to ensure that all applicable future trailers and semitrailers in the U.S. fleet will be built to the more rigorous standards.
Rear underride crashes are those in which the front end of a vehicle impacts the rear of a generally larger vehicle, and slides under the rear-impacted vehicle. For example, underride may occur in collisions in which a small passenger vehicle crashes into the rear end of a large trailer and the bed and chassis of the impacted vehicle is higher than the hood of the impacting passenger vehicle.
In excessive underride crashes, there is passenger compartment intrusion (PCI) as the passenger vehicle underrides so far that the rear end of the struck vehicle enters the passenger compartment of the striking passenger vehicle. PCI can result in severe injuries and fatalities to occupants contacting the rear end of the struck vehicle. A rear impact guard prevents PCI when it engages the smaller striking vehicle and stops the vehicle from sliding too far under the struck vehicle’s bed and chassis.
The occupant crash protection features built into today’s passenger vehicles are able to provide high levels of occupant protection in 35 mph frontal crashes. This NPRM would require trailer and semitrailer guards to remain in place and prevent PCI in crashes of severities of up to 35 mph versus the current requirement of up to 30 mph.
Comments on the NPRM on trailer and semitrailer rear underride protection can be submitted to the docket up to 60 days after publication in the Federal Register.
J. J. Keller's Driver Training Series: Accident Procedures provides suggested step-by-step procedures of what must be done in the event of a crash.
J. J. Keller's FREE Transportation SafetyClicks™ email newsletter brings quick-read safety and compliance news right to your email box.
Sign up to receive Transportation SafetyClicks™.