J. J. Keller® Glide’NGo™ Placard Holder with Back Plate - Painted White, 4 Clipped Corners

• Proprietary J. J. Keller® design side rails make it easier to slide hazmat placards in and out of the holder than typical placard holders.
• Proprietary J. J. Keller® thumb notches in the face plate make it simple to push placards in and out
• Improved ramp design helps placards glide over the retaining clip without catching
• Elongated bumper ribs raise placards off the back plate to prevent “suctioning” due to moisture/freezing
• Embossed “UP” arrow helps ensure proper holder orientation during installation
• Stainless-steel Dura-Clip® low-profile snap fastener keeps placards in the holder
• Drain hole allows water/debris to channel out of the frame
• Stores up to 4 placards
• Pre-drilled mount holes allow for secure attachment to equipment (mount holes are backwards compatible with prior version J. J. Keller® placard holders, no redrilling needed)
• Available in unpainted aluminum mill finish, white painted aluminum finish, or bright annealed stainless-steel finish
• Available in 3 different configurations:
  • Full frame - installation orientation dimensions (corner to corner) – 17.65” W x 17.65” H
  • 4 clipped corner frame - installation orientation dimensions (corner to corner) – 16.38” W x 14.98” H (ideal for roll-up doors with 15” or larger panels)
  • Split frame - installation orientation dimensions (corner to corner) – 16.38” W x 8.09” H top half, 15.99” W x 6.89” H bottom half (ideal for roll-up doors with smaller than 15” panels)
• Common equipment uses: van trailers, tanker trailers, box trucks, chemical storage tanks
• Common applications: hazmat hauling
• Made in the USA with foreign & domestic components

WARNING: This product can expose you to Chromium - Hexavalent and Nickel, which are known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.